Automatic Timer; The Timer; Cleaning Lock Function; Automatic Time Limitation - Bosch PIE975N14E Instruction Manual

Changing or cancelling the time
Select the hotplate and press the
The __ and displays appear
r
Change the cooking time using symbols 1 to 9 or press 0 to
cancel the time.
Notes
If a cooking time has been programmed, the display always
■
shows the time of this function. To check the cooking time
remaining in a hotplate, select a hotplate and press the
symbol twice.
0
If a time has been programmed for several hotplates, the
■
time of the selected hotplate is always shown.
Any cooking time can be programmed for up to 99 minutes.
■

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time can be changed or cancelled for any
hotplate:
Press the 0 symbol several times until the
required hotplate lights up. Adjust the cooking time with
symbols 1 to 9 or deactivate with the symbol 0.

Cleaning lock function

Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the >D symbol. A signal sounds. The control panel is
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator / flash alternatively in the display.
œ •
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
symbol twice.
0
$ indicator of the
symbol and the residual
"‰

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the symbol. The indicator
0
1.
in the time program function display.
Set the required time using symbols 1 to 9.
2.
The time starts again after a few seconds.
Once the time has elapsed
Once the time has elapsed, a beep will sound.
displayed in the time program function display. After pressing
the symbol, the indications turn off.
0
Changing or cancelling the time
Press the symbol, the
0 U
Change the time using the 1 to 9 symbols or press 0 to cancel.
Note: The lock does not affect the main switch. The hob may
be switched off when desired.
lights up. lights up
U ‹‹
and
‹‹
indicator lights up.
are
U
11