Making Settings; After Cleaning; Care And Cleaning; Cleaning Agents - Bosch HBG53R550B Instruction Manual

Making settings

Cleaning takes approximately one hour.
Set the function selector to
1.
Set the temperature selector to
2.
Press the u button.
3.
The symbol lights up in the display. The time at which the
u
cleaning will end appears and the
Cleaning will start after a few seconds. You will see the time
counting down and the
r
symbol goes out.
Cleaning is finished
A signal sounds. The oven stops heating. 00:00 is shown in the
display. Press the button twice and turn the function selector
0
to the off position. The oven switches off.
Cancelling cleaning
Press the u button and turn the function selector to the off
position. The oven switches off.

Care and cleaning

With good care and cleaning, your oven will remain clean and
fully-functioning for a long time to come. Here we will explain
how to maintain and clean your oven correctly.
Notes
Slight differences in the colours on the front of the oven are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Area Cleaning agents
Oven front Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Do not use glass cleaners or glass
scrapers.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Remove flecks of limescale, grease,
starch and albumin (e.g. egg white) immedi-
ately. Corrosion can form under such resi-
dues.
Special stainless steel cleaning products
suitable for warm surfaces are available
from our after-sales service or from special-
ist retailers. Apply a thin layer of the cleaning
product with a soft cloth.
3D hot air.
<
s .
symbol is in brackets.
p
symbol will be in brackets. The
Setting a later end time
You can delay the time at which the cleaning programme is due
to finish. For instance, you can set the cleaning programme to
run at night so that you can use your oven during the day.
Make the settings as described in steps 1 to 3. Before cleaning
starts, use the
@
The oven switches to standby. The display shows the time at
which the cleaning will finish and the
When cleaning starts, you can see the time counting down in
the display and the
p
goes out.

After cleaning

When the cooking compartment has cooled down completely,
wipe the salt residues off the self-cleaning surfaces with a
damp cloth.
Area
Door panels
Glass cover for
the oven light
Seal
Do not remove.
Shelves
Telescopic
shelves
Accessories
Cleaning the self-cleaning surfaces in the cooking
compartment
The back wall, ceiling and side walls of the cooking
compartment are coated with a highly porous ceramic layer.
This coating absorbs and disintegrates splashes from baking
and roasting while the oven is in operation. The higher the
temperature and the longer the oven is in operation, the better
the result will be.
Never treat the self-cleaning surfaces with oven cleaner.
If the self-cleaning surfaces no longer clean sufficiently, they
can be regenerated with the cleaning system. For more
information, please see the Cleaning system section.
Light discolouration of the coating does not affect automatic
self-cleaning.
Caution!
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never treat the ceramic coating with oven cleaner. If oven
■
cleaner accidentally gets onto it, remove it immediately with a
sponge and plenty of water.
Cleaning the cooking compartment floor
Use a dish cloth and hot soapy water or a vinegar solution.
If there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.
or button to set a later end time.
A
p symbol is in brackets.
r symbol is in brackets. The
Cleaning agents
Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Hot soapy water:
Clean with a dish cloth.
Hot soapy water:
Clean with a dish cloth. Do not scour.
Hot soapy water:
Soak and clean with a dish cloth or brush.
Hot soapy water:
Clean with a dish cloth or a brush. Do not
soak or clean in the dishwasher.
Hot soapy water:
Soak and clean with a dish cloth or brush.
p symbol
13