Making Connections; Connecting The Power; Connecting An Antenna Or Cable Tv - Dynex DX-LDVD19-10A User Manual

DX-LDVD19-10A_09-0340.book Page 8 Tuesday, April 28, 2009 4:43 PM
8
DX-LDVD19-10A

Making connections

Cautions:
Check the terminals for position and type before making any connections.
Loose connections can result in image or color problems. Make sure that
all connections are tight and secure.
The external audio/video equipment shown in these illustrations may be
different from your equipment. If you have questions, refer to the user
manual that came with your equipment.
Always turn the power off when connecting external equipment.

Connecting the power

To connect the power:
• Plug the AC cord into an AC power outlet.
Notes:
Your TV should only be operated from the power source indicated on the
label.
Always unplug the AC power cord from the AC power outlet when you will
not be using your TV for an extended period of time.

Connecting an antenna or cable TV

To connect an antenna, cable TV, or satellite TV box:
1 Connect one end of a 75 ohm cable (not included) to the RF OUT
jack on the antenna or on the cable or satellite TV box.
Multi-family dwellings or apartments
Connect to wall antenna outlet.
Wall antenna outlet
75 ohm RF coaxial wire
VHF antenna
Turn clockwise to tighten
UHF antenna
Single-family dwellings or houses
Connect to wall antenna jack for
outdoor antenna.
2 Connect the other end of the cable to the ANT/CABLE IN jack on
the back of your TV.
Notes:
Use a 75 ohm cable to eliminate interference and noise from radio waves.
Do not bundle the 75 ohm cable with the power cord or other cables.
If the antenna is not installed correctly, contact qualified service personnel
to correct the problem.
To improve picture quality in a poor signal area, purchase and install a
signal amplifier.
Connecting a cable TV or satellite box
If you subscribe to a cable TV service from a local provider you can watch
cable TV programming. The TV cannot display TV programming unless a
TV tuner device or cable TV converter box is connected to the TV.
For further information regarding cable TV service, contact your local
cable TV service provider(s).
To connect to a cable TV or satellite TV box:
1 Connect the incoming cable from the satellite wall jack to the
SATELLITE IN jack on the satellite box.
ANT/CABLE IN
Bronze wire - do not bend
Bronze wire - do not bend
Making connections
2 Depending on the jacks available on the satellite TV receiver (set
top box), connect a cable from the outgoing jacks on the satellite
box to the corresponding jacks on the back of your TV. The
connection can be to the HDMI, component video, S-Video, or AV
jack.
3 If you use a component video, S-Video, or AV cable, connect audio
cables to the corresponding jacks on the back of your TV and on
the staellite box.
4 Turn on your TV, then press INPUT to select VIDEO mode for the
type of connection you use.
5 Select the channel you want with the remote control for the
cable box.
Cable box
Back of TV