Kyocera FS 1100 - B/W Laser Printer Service Manual page 43

Code
6000 Broken fuser heater lamp wire
The fuser temperature does not rise after
the fuser heater lamp has been turned
on.
6020 Abnormally high fuser thermistor
temperature
Fuser thermistor detects abnormally
temperature.
6030 Broken fuser thermistor wire
Input from fuser thermistor is 0 (A/D
value).
Contents
Causes Check procedures/corrective measures
Poor contact in the Reinsert the connector (See page 1-5-16).
fuser thermistor
connector termi-
nals.
Poor contact in the Reinsert the connector (See page 1-5-16).
fuser heater lamp
connector termi-
nals.
Fuser thermistor Replace the fuser unit (See page 1-5-16).
installed incor-
rectly.
Fuser thermal cut- Replace the fuser unit (See page 1-5-16).
out triggered.
Fuser heater lamp Replace the fuser unit (See page 1-5-16).
installed incor-
rectly.
Broken fuser Replace the fuser unit (See page 1-5-16).
heater lamp wire.
Shorted fuser ther- Replace the fuser unit (See page 1-5-16).
mistor.
Defective control Replace the control PWB (See page 1-5-
PWB. 19).
Poor contact in the Reinsert the connector (See page 1-5-16).
fuser thermistor
connector termi-
nals.
Broken fuser ther- Replace the fuser unit (See page 1-5-16).
mistor wire.
Fuser thermistor Replace the fuser unit (See page 1-5-16).
installed incor-
rectly.
Fuser thermal cut- Replace the fuser unit (See page 1-5-16).
out triggered.
Fuser heater lamp Replace the fuser unit (See page 1-5-16).
installed incor-
rectly.
Broken fuser Replace the fuser unit (See page 1-5-16).
heater lamp wire.
Remarks
2H5/2HS
1-4-7