Config.security.authentication.radius.deleteserver; Config.security.authentication.radius.server - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Purpose
Parameters
Command Example

config.security.authentication.RADIUS.deleteServer

Syntax
Purpose
Parameters
Command Example

config.security.authentication.RADIUS.server

Syntax
Purpose
This command configures the number of minutes a RADIUS server is
marked as "dead". If a RADIUS server does not respond to an
authentication request, it can be marked as "dead" for a specified
time interval. This may speed up authentication by eliminating
timeouts and retransmissions. If no alternate RADIUS servers are
available (when only one server is configured or when all are marked
dead), then the deadtime is ignored. Deadtime may be 0 to 1440
minutes. The default is 0.
This command has one required parameter:
minutes The number of minutes a RADIUS server is
marked "dead" before it is contacted again.
Valid values are between 0 and 1440.
Root> config security authentication RADIUS deadtime 120
deleteServer index
This command removes a RADIUS server from the RADIUS server
list. If you delete a server, and there are servers configured in higher
numbered slots, these servers will be automatically moved up to the
first available slots.
This command has one required parameter:
index Index of the server to be removed.
Root> config security authentication RADIUS deleteServer
3
server index [IP:port]
This command adds or modifies one RADIUS server at a given index
that will be used for authentication. Servers are queried in the order
listed so the primary server must be the first one in the list.
config
CLI Commands
2-45
2