Table of Contents
Advertisement
6. Tap OK twice to return to the Dial-up Connection window.
7. Tap on the Connect button. The following messages appear
successively: "Opening Port", "Dialing...",... "User
Authenticated" and "Connected". The GPRS connection
is now established.
8. Tap Hide to close the message window.
9. Tap
to close the Connection window.
10.Now it's time to select your DGPS mode (refer to Select-
ing a DGPS Mode on page 28).
Troubleshooting
You may encounter problems when attempting to establish the
GPRS connection (Step 6 above). The table below may help
you solve the problem.
Message
"
No Carrier Detected. Verify phone
number and then try again.
"
You have been disconnected from
the remote computer you dialed. Retry
the connection."
"The port is not available: it is either
configured incorrectly or another pro-
gram is using it."
Important
! The Password and Domain fields (see Step 6) are
intentionally corrupted when next opening the Dial-up con-
nection. This is done for safety purposes. You don't need to re-
type these parameters. The correct values are stored in the
unit.
- Double-tap connection icon
- Tap Dial Properties button
"
- Tap Edit button
- Reset all fields to "G".
On the cell phone, check that the
GPRS connection capability is
activated.
Check all data entries performed
during steps 5 and 6.
Action
25
Advertisement
Table of Contents
