Advertisement
Quick Links
Model 103B11
ICP® Dynamic Pressure Sensor
Installation and Operating Manual
For assistance with the operation of this product , contact the Pressure
Division of PCB Piezotronics, Inc.
Division toll-free 888-684-0015
SM
24-hour SensorLine
716-684-0001
Fax 716-686-9129
E-mail pressure@pcb.com
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for PCB Piezotronics 103B11
Summary of Contents for PCB Piezotronics 103B11
- Page 1 Model 103B11 ICP® Dynamic Pressure Sensor Installation and Operating Manual For assistance with the operation of this product , contact the Pressure Division of PCB Piezotronics, Inc. Division toll-free 888-684-0015 24-hour SensorLine 716-684-0001 Fax 716-686-9129 E-mail pressure@pcb.com...
- Page 2 The information contained in this document supersedes all similar information that may be found elsewhere in this manual. Total Customer Satisfaction – PCB Piezotronics guarantees Total Customer Satisfaction. If, at any time, for any reason, you are not completely satisfied with any PCB product, PCB will repair, replace, or exchange it at no charge.
- Page 3 Materials Authorization Number. This RMA number should be clearly marked on the outside of all package(s) and on the packing list(s) accompanying the shipment. A detailed account of the nature of the problem(s) being experienced with the equipment should also be included inside the package(s) containing materials.
- Page 4 DESCRIPTION The Series 103A microphones are high-sensitivity pressure sensors featuring miniature size, built-in solid state electronics and acceleration compensation. The Model 103A (see installation drawing) has pigtail leads extending radially from the side of the unit and has a nominal sensitivity of 1500 mV/psi. The Model 103A11 is similar in appearance and in mode of electrical connection, but differs from the Model 103A in that the sensitivity is nominally 500...
-
Page 5: Installation
The result is a two-wire system, precluding the need for multi-conductor cabling. A second diaphragm, located behind the pressure diaphragm and attached to another bimorph bender crystal acting in opposition to the pressure crystal, provides acceleration compensation to the Series 103A Sensors. -
Page 6: Maintenance And Repair
Refer to Guide G-0001B for tips on power and signal utilization. NOTE: The internal low-noise amplifier in the Model 103A, A02, A11 and A12 differ from the ® standard ICP amplifiers described in Guide G- 0001B in that the turn-on (or bias) voltage is nominally +4 volts.
Need help?
Do you have a question about the 103B11 and is the answer not in the manual?
Questions and answers