Pioneer BDP-53FD Operating Instructions Manual page 42

07
Setting
Digital Output
DTS Downmix (BDP-53FD)
Downsampling
DRC (Dynamic Range
Control)
* Only Dolby digital and
analog audio signals are
supported.
42
En
Options Explanation
Bitstream Select this to output digital audio signals directly.
PCM Select this to output digital audio signals converted to PCM audio signals.
Re-encode Select this to output digital audio signals converted to DTS Digital Surround.
Off Select this to output audio signals other than digital audio signals.
Stereo DTS-HD Master Audio signals, DTS-HD High Resolution Audio signals or
DTS Digital Surround audio signals converted to linear PCM audio signals
are converted into 2-channel (stereo) signals for output.
Lt/Rt DTS-HD Master Audio signals, DTS-HD High Resolution Audio signals or
DTS Digital Surround audio signals converted to linear PCM audio signals
are converted into 2-channel signals compatible with Dolby Surround for
output (when the connected AV receiver or amplifier, etc., is compatible with
Dolby Pro Logic, the AV receiver or amplifier outputs the linear PCM audio
signals as surround audio signals).
48k Select this when playing a disc recorded with a sampling frequency of 48 kHz.
96k Select this when playing a disc recorded with a sampling frequency of 96 kHz.
192k Select this when playing a disc recorded with a sampling frequency of 192
kHz.
Off Select this to output audio signals without using the DRC function.
On Select this to adjust the range between the loudest and softest sounds
(dynamic range) for playback at average volume. Use this when it is hard to
hear dialog or when watching movies at midnight.
Auto Select to switch the DRC setting On/Off automatically according to the input
audio signal from the disc.