Getting To Know Your Dishwasher; How To Fill The Salt - Haier DW12-PFE1 ME User Manual

Getting to know your dishwasher

Close-up view (control panel)
A
A
ON-OFF Button
B
Programme Button

How to fill the salt

Salt
The hardness of the water varies from place to place. If hard water is used in
the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically
designed to eliminate lime and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as
follows:
According to the "Water Hardness Tabel", you can calculate the salt con-
sumption setting, then load the salt .
Remove the lower rack and then unscrew and remove the cap from the salt
container.
If you are filling the container for the
first time, fill it with 1/2 a litre of water.
Place the end of the funnel (supplied)
into the hole and fill with about 2 kg
of salt. It is normal for a small amount
of water to come out of the salt container.
Carefully screw the cap back on. Do not
over tighten it.
Important
To prevent the formation of rust, load the salt just
before beginning a wash cycle.
DW12-PFE1 DW12-PFE1 ME
Dishwasher
a
b
C
a
b
c
B
d
e
C
Programme Indicator
f
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed
based on the hardness of the water used. This is intended to optimize the amount
of salt consumption keeping it to a minimum.
To adjust salt consumption, proceed as follows:
It is recommended that adjustments be made in accordance with the following
table:
Level
1
2
3
4
3
interior
c
d
h
Upper Rack
g
Washing Filter
Lower Rack h
Detergent and Rinse Aid Dispenser
Top Spray Arm i
Water Inlet Hose
Silverware Basket j
Drain Hose
k
Bottom Spray Arm
Power Supply Cord
Salt Container Cap
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure below ).
If necessary, rotate the ring in an anticlockwise direction from the "-" set-
ting towards the "+" sign, based on the hardness of the water being used.
Water Hardness
Selector
Clarke
º
dH
mmol/l
position
degrees
0 14
EN
i
j
e
f
k
g
Salt
Autonomy
c o n s u m p t i o n
(cycles/2kg)
(Grams/cycle)