Sony HVRM25AU - Professional Video Cassete recorder/player Operating Instructions Manual page 81

Icon/Menu Submenu
OTHERS PB YNR
PB CNR
SPEAKER/
BEEP
(page 7)
CLOCK SET
(page 48)
HOURS
METER
(page 95)
AC ON MODE Switches the state into which the unit goes when it is connected to the AC outlet.
AUTO
STANDBY
Setting
Selects the noise reduction level for the luminance signals when a tape is played.
BOFF : No noise reduction
LOW : Low noise reduction
HIGH : High noise reduction
Notes
• When you use noise reduction, there may be an afterimage depending on the condition of
the picture.
• Noise reduction is also available with pictures output from the
when dubbing and editing a picture via the
Selects the noise reduction level for the chrominance signals when a tape is played.
BOFF : No noise reduction
LOW : Low noise reduction
HIGH : High noise reduction
Notes
• When you use noise reduction, there may be an afterimage depending on the condition of
the picture.
• Noise reduction is also available with pictures output from the
when dubbing and editing a picture via the
Sets beeps and/or sounds from the speaker of the unit ON/OFF.
When headphones are connected, sounds are heard from the headphones and no sound is
produced from the built-in speaker, regardless of this setting.
BON[SPK/BEEP] :Outputs both beeps and speaker sounds.
ON[SPEAKER] : Outputs sounds from the speaker only and disables beeps.
ON[BEEP] : Outputs beeps and emits no sounds from the speaker.
OFF : Disables beeps and does not output sounds from the speaker.
1 Press the J/j buttons to adjust the number, then press the K/k buttons to set the
month, day, hour, and minute.
2 Press the EXEC button to execute.
Notes
• 12:00 AM stands for midnight and 12:00 stands for noon when [TIME DISPLAY] in
[DISPLAY SET] menu is set to [12H].
• If you do not use the unit for 3 months or more, the built-in rechargeable battery will
become completely discharged, and the settings of the day and the time may be cleared
from the memory. In this case, charge the built-in rechargeable battery and set the clock
again (page 95).
Displays the accumulated time counts (using the digital hours meter) in units of 10 hours or
10 counts.
OPERATION :Power on duration
DRUM RUN : Drum rotation duration
TAPE RUN : Tape run duration
THREADING :Tape unthreading count
BSTANDBY : Makes the unit go into the standby mode.
ON : Turns the unit on.
Selects whether the unit goes into the standby mode or not, if the unit has been in the stop
mode and no key operations have been attempted for more than one hour.
BOFF : Leaves the unit in the stop mode.
ON : Makes the unit go into the standby mode.
HDV/DV jack. Use caution
HDV/DV jack.
HDV/DV jack. Use caution
HDV/DV jack.
Chapter 5 Adjusting and Setting Through Menus
(Continued)
81