Sony HVRM25AU - Professional Video Cassete recorder/player Operating Instructions Manual page 37

Notes
• To playback an image recorded in HDV format when
you connect the monitor using an HDMI cable or a
component video cable, set [HDMI/CMPNT] of
[VIDEO OUT] in the [IN/OUT REC] menu according
to the requirements of your monitor (page 71).
• When an image recorded in DVCAM/DV format is
played back, only an image with a quality equivalent to
that of the DVCAM/DV format of 480i (NTSC) or
576i (PAL) is output via the COMPONENT OUT
jacks, regardless of the [HDMI/CMPNT] setting.
• For details on the output level from the HDMI OUT
jack and the COMPONENT OUT jacks, see
"Specifications" (page 100).
• To change the output level from the COMPONENT
OUT jacks, see [480i LEVEL] in the [IN/OUT REC]
menu (page 74).
• There are some restrictions on images output from the
HDMI OUT jack and the COMPONENT OUT jacks
of the unit.
Refer to HDMI OUT jack 6 (page 17), COMPONENT
OUT jacks 5 (page 17) of "Location and Function of
Parts."
For more information, see "Recording Format and Input/
Output Signals" on page 31.
• If you connect the input connectors of the unit to the
output connectors of a monitor, a humming noise may
be generated or the image may be distorted. If these
phenomena occur, use the INPUT SELECT switch to
select a signal that is not being input, or disconnect the
cables.
• When you play back an HDV-formatted tape with
copyright protected signals or input HDV signals with
copyright protection to the
may be output in either 480i (NTSC) or 576i (PAL)
format, regardless of the setting of [HDMI/CMPNT]
of [VIDEO OUT] in the [IN/OUT REC] menu.
• The unit cannot up convert DVCAM/DV recordings to
HDV at output.
• When [HDMI/CMPNT] of [VIDEO OUT] in the [IN/
OUT REC] menu is set to either [1080i/480i] or
[1080i/576i], 1080/24p and 1080/30p video signals
played back are converted to 1080/60i and 1080/25p
video signals are to 1080/50i, and output from the
COMPONENT OUT jacks and the HDMI OUT jack.
HDV/DV jack, pictures
Connecting the unit to a monitor equipped
with an i.LINK jack
The video and audio signals are sent with hardly any
degradation, enabling high-quality playback to a
monitor with an i.LINK connector that supports HDV,
DVCAM, and DV formats.
For details on i.LINK output formats, see page 97.
i.LINK cable (not supplied)
Notes
• Be sure that you set [HDV/DV SEL] in the [IN/OUT
REC] menu to [AUTO] (default setting) before
connecting the monitor to the unit with the i.LINK
cable. If you change the setting after connecting the
i.LINK cable, the monitor may not recognize the video
signals correctly (page 70).
• To connect the unit to a monitor equipped with an
i.LINK jack, you may need to set the monitor so that it
recognizes the unit.
For details, refer to your monitor's instruction manual.
• When an i.LINK connection is made, the unit cannot
output video or audio only.
Chapter 2 Playback and Recording
HVR-M25A
(rear panel)
To i.LINK jack ( HDV/DV jack)
Monitor with i.LINK jack
: Signal flow
(Continued)
37