Installing A Media Card Reader - Dell Dimension 9100 Owner's Manual

5 Disconnect the USB cable on the back of the Media Card Reader to the front panel USB
connector on the system board (see page 63) and route the cable through the clip on the
shroud.
sliding plate lever
sliding plate
*Media Card Reader
*
Not present on all computers.
6 While pushing on the back of the drive, remove the Media Card Reader by sliding and
holding the sliding plate.
7 Replace the drive panel (see page 84).
8 Replace the computer cover (see page 102).

Installing a Media Card Reader

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
Removing and Installing Parts
95