Table of Contents
Advertisement
Auto Setup OS/2
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of
the dot pattern varies with
the screen resolution.
Position the mouse pointer
at the bottom center of the
A
screen. This allows
UTO
S
to run properly.
ETUP
1.
Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
•
that the video interface cable is connected properly.
•
the correct video adapter card is installed.
•
the correct supported display mode is selected for your PC.
2.
Wait approximately 15 minutes, until the monitor warms up.
3.
Insert the diskette labelled 'IBM Monitor Installation Disk' into the
diskette drive.
4.
Select
OS/2 S
YSTEM
.
1024
768
256
X
X
5.
Select
S
R
CREEN
EFRESH
6.
Close
and restart your system.
S
YSTEMS
7.
At the OS/2 command prompt, select the
8.
Press mouse button 2 and select
your OS/2 version).
9.
Select
and then choose
S
ESSION
10. Open the OS/2 full-screen window.
11. At the command prompt type A: and press ENTER.
12. Type TESTPATS and press ENTER.
13. When the dot pattern appears, press the OSD Enter button
the bottom of the monitor to display the initial OSD menu.
14. Use an Arrow button (
and press the OSD Enter button
15. Using an Arrow button (
OSD Enter button
will optimize the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice
small changes to the test pattern.
To abort the
A
UTO
,
,
S
S
S
YSTEMS
ETUP
YSTEM
of
.
60H
Z
S
ETTINGS
W
-OS/2
IN
or
) to select the
to access the function.
or
), select
. This activates the
A
function, press the
S
ETUP
. Select
S
R
CREEN
ESOLUTION
command.
OS/2
FULL SCREEN
or
(depending on
P
ROPERTIES
.
FULL SCREEN
along
icon
IMAGE LOCK
and press the
AUTOMATIC
procedure, which
S
UTO
ETUP
key.
ESCAPE
11
Hide quick links:
Advertisement
Table of Contents
