Hitachi DV18DCL - 18V 1.5Ah Lithium Ion Hammer Drill Instruction Manual page 18

Instruction manual
Table of Contents

Advertisement

Available languages

Available languages

English
13. Using the hook (Hook with bit holder)
WARNING:
When using the hook, pay sufficient attention so
that the main equipment does not fall. If the tool
falls, there is a risk of accident.
CAUTION:
Do not attach the tip tool except phillips bit to the
tool main unit when carrying the tool main unit
with the hook suspended from a waist belt.
Injury may result if you carry the equipment
suspended from the waist belt with sharp tipped
components such as drill bit attached.
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow
(B) (Fig. 14).
Fig. 14
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
If the tool falls, there is a risk that malfunction and/
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.
Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin (Fig. 15).
Loosen
Fig. 15
18
Hook
Screw
(b) Remove the hook and spring (Fig. 16).
Hook
Fig. 16
(c) Install the hook and spring on the other side
and securely fasten with screw (Fig. 15).
NOTE:
Pay attention to the spring orientation. Install the
spring with larger diameter away from you (Fig.
17).
Screw
Larger diameter faces away
Fig. 17
14. Using the bit holder (Hook with bit holder)
Installing the bit
Slide the bit from the side, and then insert firmly
until the groove on the bit locks in the protruded
section of the hook.
Removing the bit
Securely hold the main unit and pull out the bit by
holding the tip with your thumb (Fig. 18).
Fig. 18
CAUTION:
Only Hitachi STANDARD ACCESSORIES phillips
bit (No. 2 65L; Code No. 983006) may be used.
Do not use other bits since they may come loose.
Spring

Advertisement

Table of Contents
loading

Table of Contents