Hitachi DH30PC2 - 1 3/16 Inch SDS Instruction Manual page 15

6. Hammering only
This rotary hammer can be set to
hammering only mode by pressing the
push button and turning the change
lever to mark. (Fig. 9)
(1) Mount the bull point or cold chisel.
(2) Press the push button and set the
change lever to
The rotation is released, turn the grip
and adjust the cold chisel to desired
position. (Fig. 10)
(3) Turn the change lever to
(Fig. 9)
Then bull point or cold chisel is locked.
7. Using the stopper (Fig. 11)
(1) Loosen the side handle, and insert the
stopper into the handle bolt hole.
(2) Adjust the stopper position according
to the depth of the hole and tighten the
side handle securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 12)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 12)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
(4) To remove the drill bit (taper shank),
insert the cotter into the slot of the taper
shank adaptor and strike the head of
the cotter with a hammer supporting
on the rests. (Fig. 13)
Drill bit
Taper shank
adaptor
mark.
mark.
Front cap Grip
Fig. 12
Change lever
Fig. 9
Grip
Fig. 10
Handle bolt
Stopper
Fig. 11
Cotter
Taper shank adaptor
Rests
Fig. 13
English
Push button
Knob on side
handle
15