Lenovo ThinkServer RD230 User Manual page 44

3. If you are instructed to return the removed hard disk drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 67.
Installing a hot-swap hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 19.
This section provides instructions on how to install a hot-swap hard disk drive. This section applies only to
server models that support hot-swap hard disk drives.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each drive bay.
Notes:
1. You do not have to turn off the server for the installation of a hot-swap hard disk drive.
2. The cables come with the SATA hard disk drive option kit will not be used in this server.
To install a hot-swap hard disk drive, do the following:
1. Rotate the drive tray handle
the handle and pull the drive tray assembly out of the bay.
Figure 18. Removing the hard disk drive tray assembly
32
ThinkServer User Guide
2 of the hard disk drive tray assembly 1 to the open position. Then, grasp