Controlling The Projector Via Lan; Controlling The Projector Using Internet Explorer (Version 5.0 Or Later) - Sharp PG-F255W - Notevision WXGA DLP Projector Setup Manual

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in "Address"
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 21-
25 of the projector's operation manual.)
Complete the AC cord connection. (See page
25 of the projector's operation manual.)
Note
• When connecting the projector to the LAN,
use a commercially available LAN cable
(UTP cable, Category 5, cross-over type).
When connecting the projector to a hub, use
a straight-through cable.
1
Start Internet Explorer (version
5.0 or later) on the computer.
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
by "/" in "Address", and then
press the "Enter" key.
• When "DHCP Client" is set to "OFF" on
the projector, IP address is
192.168.150.2. If you did not change the
IP address in "3. Setting up a Network
Connection for the Projector" (pages
13-14), enter "http://192.168.150.2/".
3
A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
14 followed
-15