Table of Contents
Advertisement
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following ONE of these steps.
1.
Press
projector or remote control to display the
status bar labelled Keystone. Press
correct keystoning at the top of the image.
Press
bottom of the image.
2.
Press MENU/Exit on the projector or remote
control. Go to DISPLAY
adjust the values by pressing
For example,
Keystone
Keystone
Magnifying and searching for details on the
projected picture
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
•
Using the remote control
1.
Press D. ZOOM + to display the Zoom bar. The center of the
picture will be magnified when the key is pressed again. Press
the key repeatedly until the picture size is suitable for your
need.
2.
Use the directional arrows ( ,
or remote control to navigate the picture.
The picture can only be navigated after the picture is magnified. You
can further magnify the picture while searching for details.
3.
To restore the picture to its original size, press AUTO. You can
also press D. ZOOM -. When the key is pressed again, the picture is further reduced
until it is restored to the original size.
or
on the control panel of the
to correct keystoning at the
>
Keystone and
•
Press
control.
•
Press
control when you are in the Picture >
Keystone menu.
0
•
Press
control.
•
Press
control when you are in the Picture >
Keystone menu.
0
to
or
on the projector or remote control.
on the projector or remote
on the projector or remote
on the projector or remote
on the projector or remote
,
,
) on the projector
Keystone
+6
Keystone
-6
Operation
29
Advertisement
Table of Contents
