Lexmark C544DTN - Color Laser Printer 25/25 Ppm Duplex Networkfront Pic Wireless Setup Manual page 29

Wireless Setup Utility stops responding during
wireless printer configuration
If the Wireless Setup Utility stops responding during the wireless configuration process, restart the computer. Insert
the Software and Documentation CD and run the Wireless Setup Utility again.
Printer does not print after wireless configuration
completes
These are possible solutions. Try one or more of the following:
M
AKE SURE THE PRINTER IS TURNED ON
•
Verify that printer is turned on and the power light is lit.
•
Verify that the printer is plugged in to a functioning power strip or outlet.
V
ERIFY THAT THE PRINTER IS READY
•
Check the status of the printer and verify that it is ready to print.
•
If it is not ready, turn the printer off and then back on again.
D -
ISABLE THIRD PARTY FIREWALLS
•
If a non-Microsoft software firewall is installed on the computer, try temporarily disabling it. Check to see if you
can print with the firewall disabled. Re-enable the firewall and continue to troubleshoot.
•
Update any non-Microsoft firewall software on the computer.
•
Add any programs associated with the printer to the firewall whitelist.
V
ERIFY THAT THE WIRELESS NETWORK IS WORKING PROPERLY
•
Try to access other devices on the wireless network to confirm that the network is functioning.
•
Contact the system support person to confirm that the network is functioning correctly.
V
ERIFY THAT THE CORRECT PORT OR PRINTER IS SELECTED
•
If you are attempting to print wirelessly, verify that the USB port is not selected.
•
If you have more than one instance of the printer installed, verify that the correct printer is selected.
V W
ERIFY THAT INDOWS IS WORKING PROPERLY
•
Try restarting the computer.
•
Try installing the printer driver again.
•
Try uninstalling, and then reinstalling the printer driver.
Troubleshooting wireless setup
29