Introduction - Hayward Universal ColorLogic Installation And Operation Manual

Congratulations on your purchase of a Hayward
Hayward that generates colored light and effects using a microprocessor to control red, green, blue, and white LED's.
Your Hayward Universal ColorLogic/CrystaLogic underwater pool or spa light has these special features:
1. Long-lasting LED's (light-emitting diodes) which can last up to 10 times longer than current incandescent or halogen pool and spa lights.
2. Multicolor capability without any color wheels or moving parts to wear out.
3. Multi color program capability which allows you to select any one of 17 different programs, 10 fixed colors, and 7 color shows in stand-alone mode.
4. When networked with a Hayward Pro Logic
ditional shows, 101 fixed light colors and offer custom speed, brightness and motion control.
5. Offers spectacular brilliant light with low power consumption. Uses up to 86% less energy than a typical incandescent pool light.
The 12 volt Hayward Universal ColorLogic and CrystaLogic LED (light-emitting diode) underwater lighting fixtures you have purchased are UL Listed to be
installed in all Hayward or any other manufacturer's light fixture housing (niche).
Installation of light and niche must be in accordance with Article 680 of the National Electrical Code (NEC) and any applicable local codes. Ensure that your
niche is properly grounded and bonded. NOTE: the Hayward LFGUY1000 low profile, all plastic niche does not require bonding or grounding.
Because of the all plastic design with an impact resistant lens, these lights can be installed as little as 4 inches (10cm) from below the normal water level
of the pool or spa to the top of the lens. It can also be installed upward facing without a rock guard for lighting ponds, fountains, or water falls.
Important Note When Installing LFGUY1000 Niches in Concrete/Gunite Pools:
LFGUY1000 Niche: A gunite/plaster shield is provided to protect the niche and ring during construction. The shield is designed to be installed during the
gunite and plastering process. When finished guniting, pull on the tab and remove the outer ring of the shield. Keep the shield in place while plastering
and until the light is ready to be installed.
GIVE THESE INSTRUCTIONS TO POOL/SPA OWNER AFTER INSTALLATION

Introduction

Universal ColorLogic /CrystaLogic
® ®
pool/spa controller, Universal ColorLogic lights (LSCUN11xxx and LPCUN11xxx) are capable of 4 ad-
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
LED Light. Welcome to a more colorful world brought to you by
TM
3