Removing Cartridges; Cleaning Cartridges - Hayward SwimClear Owner's Manual

Page 6 of 12
Figure 5

REMOVING CARTRIDGES

1. Remove the top closure plate, which is exposed when the upper filter body is
removed. (Fig 4)
2. Remove the filter cartridge elements by using slight rocking motion and lifting up.
3. Clean filter cartridge elements.

CLEANING CARTRIDGES

The Cartridge filter element can be cleaned by washing inside and outside with a garden hose. After hosing cartridge, for
best results, carefully brush the pleated surface to remove fine particles. Do not pressure wash as it can damage the filter
element.
You may find some debris on the cartridge pleats, which may not have been removed with hosing.
SWIMCLEAR CARTRIDGE FILTER
MAINTAINING YOUR FILTER
qualified pool professional.
FILTER DISASSEMBLY INSTRUCTIONS
1. Turn off all system circulation pumps and all electric power on
2. Set all system valves in a position to prevent water flow to the
3. The manual air relief valve must be placed in the OPEN
4. Remove filter drain plug (Fig 4) and drain water from filter.
5. Using 3/4" wrenches, loosen and remove the clamp nut and
6. Holding both ends of the filter clamp carefully spread the
Figure 4
7. Lift off upper filter body. Do not use the pressure gauge to lift
Clamp Bolt
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
WARNING
This product should be installed and serviced only by a
the equipment pad.
filter.
position. (Fig 6)
the clamp bolt. (Fig 5)
clamp ends. Remove the clamp by lifting over the upper filter
body. Do not to drop the clamp during removal, because the
clamp could be damaged. Do not strike the clamp with metal
tools as they can damage the clamp.
the upper filter body.
Clamp Nut
ISC2028 REV C
Figure 6
Manual Air Relief Shown in Open