Ide Configuration - Asus K8N-LR User Manual

PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5

IDE Configuration

The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
IDE Configuration
OnBoard PCI IDE Controller
SATA0 IDE Interface
SATA1 IDE Interface
Hard Disk Write Protect
IDE Dectect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
First Boot Device from
Configuration nVidia RAID ROM
OnBoard PCI IDE Controller [Both]
Enables or disables any or both the primary and/or secondary IDE
controllers. Configuration options: [Disabled] [Primary] [Secondary] [Both]
SATA0 IDE Interface [Enabled]
Enables or disables the SATA0 IDE Interface.
Configuration options: [Disabled] [Enabled]
SATA1 IDE Interface [Enabled]
Enables or disables the SATA1 IDE Interface.
Configuration options: [Disabled] [Enabled]
Hard Disk Write Protect [Disabled]
Enables or disables the hard disk wirte protection. This will be effective
only if device is accessed through BIOS.
Configuration options: [Disabled] [Enabled]
ASUS K8N-LR
[Both]
[Enabled]
[Enabled]
[Disabled]
[35]
[Host]
[P-ATA]
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
SECODARY: enables
only the Secondary
IDE Controller.
BOTH: enables both
IDE Controllers.
4-15