System Panel Connector 10-1 Pin F_Panel - Asus I220GC User Manual

12. System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
I220GC
I220GC System Panel Connector
• System power LED (2-pin PWRLED)
This 2-pin connector is for the system power LED. Connect the chassis
power LED cable to this connector. The system power LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin HDLED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The IDE LED lights up or flashes when data is
read from or written to the HDD.
• ATX power button/soft-off button (2-pin PWRBTN)
This connector is for the system power button. Pressing the power button
turns the system on or puts the system in sleep or soft-off mode depending
on the BIOS settings. Pressing the power switch for more than four seconds
while the system is ON turns the system OFF.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
1-26
R
F_PANEL
GND Reset
PWR Ground
PLED-
IDELED-
PLED+ IDELED+
Chapter 1: Product introduction