Asus F1A75-V EVO User Manual page 33

3. Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1, SATA6G_1~6)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, RAID 10 or JBOD configuration through the onboard AMD
A75 FCH controller.
F1A75-V EVO
F1A75-V EVO SATA 6.0Gb/s connectors
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
4. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
F1A75-V EVO
F1A75-V EVO Serial port (COM1) connector
The COM module is purchased separately.
ASUS F1A75-V EVO
SATA6G_E1
SATA6G_5 SATA6G_6
SATA6G_3 SATA6G_4
SATA6G_1 SATA6G_2
XP Service Pack 3 or later version before using Serial
®
XP SP3 or later version.
®
COM1
PIN 1
®
1-21