System Memory (Dimm); General Dimm Notes - Asus CUSL2-C BP User Manual

3. HARDWARE SETUP

3.5 System Memory (DIMM)

NOTE: No hardware or BIOS setup is required after adding or removing memory.
This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are
available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Ac-
cess Memory (SDRAM). One side (with memory chips) of the DIMM takes up one
row on the motherboard.
Memory speed setup is recommended through SDRAM Configuration in 4.4.1
Chip Configuration.
Install memory in any combination as follows:
DIMM Location
Socket 1 (Rows 0&1)
Socket 2 (Rows 2&3)
Socket 3 (Rows 4&5)
NOTE: Make sure the total installed memory does not exceeds 512MB. Otherwise,
the system may hang during startup.

3.5.1 General DIMM Notes

• ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the
memory of choice for best performance vs. stability.
• BIOS shows SDRAM memory on bootup screen.
• Single-sided DIMMs come in 16, 32, 64,128, 256MB; double-sided come in 32,
64, 128, 256, 512MB.
NOTE: For PC133 SDRAM to run at 133MHz, the system CPU bus must also
operate at that speed.
26 ASUS CUSL2-C Black Pearl User's Manual
168-pin DIMM
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
SDRAM 8, 16, 32, 64, 128, 256, 512MB x1
Total System Memory (Max 512MB)
Total Memory
=