Irog Configuration; Ec Configuration - Asus CROSSHAIR IV EXTREME User Manual

POST State LEDs [Enabled]
[Enabled] Turn on onboard device LEDs in the order of the device POST
[Disabled] Disables this function.
Voltiminder LED [Enabled]
Allows you to enable or disable the onboard Voltiminder LED.
Configuration options: [Enabled] [Disabled]
CPU LED Selection [CPU]
Allows you to switch the onboard CPU LED display between CPU voltage
[CPU], CPU/NB voltage [CPU/NB] and CPU VDDA voltage [CPU VDDA].
Configuration options: [CPU] [CPU/NB] [CPU VDDA]
NB LED Selection [NB]
Allows you to switch the onboard northbridge LED display.
Configuration options: [NB] [NB 1.8V] [VDDPCIE]
SB LED Selection [SB]
Allows you to switch the onboard southbridge LED display.
Configuration options: [SB] [HT]
DDR LED Selection [DRAM]
Allows you to switch the onboard DDR LED display.
Configuration options: [DRAM] [VDDR]
3.5.7

iROG Configuration

iROG Configuration
iROG ID_Number Information
iROG_1 ID_Number: 21
iROG_2 ID_Number: 2
iROG Timer Keeper
Current Operation time:
Total Operation time:
iROG Timer Keeper [Last State]
Allows you to set the iROG Time Keeper operation mode.
Configuration options: [Last State] [Disabled] [Enabled]
3.5.8

EC Configuration

Shows EC BIOS information. This item is not user-configurable.
3-28
sequence.
Crosshair IV Formula BIOS Setup
Advanced
[Last State]
iROG Timer Keeper
System will record
using time every 1
minute
Chapter 3: BIOS setup