Led Control - Asus CROSSHAIR IV EXTREME User Manual

USB 2.0 Controller Mode [HiSpeed]
[FullSpeed] Set the USB 2.0 controller mode to FullSpeed (12 Mbps).
[HiSpeed] Set the USB 2.0 controller mode to HiSpeed (480 Mbps).
The USB 2.0 Controller Mode item appears only when you enable the USB
2.0 Controller.
BIOS EHCI Hand-off [Enabled]
[Enabled] Enables the support for operating systems without an EHCI
hand-off feature.
[Disabled] Disables the function.
3.5.5 PCIPnP
The PCI PnP menu items allow you to change the advanced settings for PCI/PnP
devices.
Advanced PCI/PnP Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Plug And Play O/S
Plug And Play O/S [No]
[Yes] When set to [Yes] and if you install a Plug and Play operating
system, the operating system configures the Plug and Play devices
not required for boot.
[No] When set to [No], BIOS configures all the devices in the system.
3.5.6

LED Control

LED Control
All LED Control
POST State LEDs
Voltiminder LED
CPU LED Selection
NB LED Selection
SB LED Selection
DDR LED Selection
All LED Control [Enabled]
Allows you to enable or disable the onboard LEDs control.
Configuration options: [Enabled] [Disabled]
The following items appear only when you set All LED Control to [Enabled].
ROG Crosshair IV Formula
Crosshair IV Formula BIOS Setup
Advanced
[No]
Crosshair IV Formula BIOS Setup
Advanced
[Enabled]
[Enabled]
[Enabled]
[CPU]
[NB]
[SB]
[DRAM]
3-27