Asus A7VI-VM User Manual page 34

3. HARDWARE SETUP
21) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
A7VI-VM
®
A7VI-VM ATX Power Connector
22) IDE Activity LED (2-pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary/Secondary IDE and Primary/
Secondary ATA100 connectors will cause the LED to light up.
A7VI-VM
®
A7VI-VM IDE Activity LED
34
Make sure that your ATX power supply can supply at least 10mA
Power Supply On
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
ASUS A7VI-VM User's Manual
+3.3 Volts
+3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts
IDELED