Asus A7VI-VM User Manual page 30

3. HARDWARE SETUP
13) Standard and Consumer Infrared Module Connector (5-pin IR)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard's SIR connector according
to the pin definitions.
A7VI-VM
®
A7VI-VM Infrared Module Connector
14) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake-On-LAN features are enabled
(see 4.4.3 Power Management) and that your system has an ATX power supply
with at least 720mA +5V standby power.
A7VI-VM
®
A7VI-VM Wake-On-LAN Connector
30
IR
1
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOL_CON
ASUS A7VI-VM User's Manual
Front View
IRTX
GND
Ground
PME +5 Volt Standby
Back View
+5V
(NC)
IRRX