Download  Print this page

Installation Instructions; Remove Mounting Plate; Rotate Blower Motor - Maytag MMV4203DB - 2.0 cu. Ft. Combination Range Hood-Microwave Installation Instructions Manual

Installation instructions
Hide thumbs

Advertisement

INSTALLATION
R@mOV@
M _¸_° _ ti_
_¸ 12" l_1_(._
'
NOTE: To avoid possible damage to the work surface, cover the
work surface.
1. Remove any remaining contents from the microwave oven
cavity.
2. Remove the 2 screws that attach the mounting plate to the
back of the microwave oven, then remove mounting plate and
set aside.
,
\
''
¢==z==
r- oooooooooooooooooo I ooooooo
[30
000_
00000_
0000000000000000
0[3
A
B
A. Mounting plate
B. Back of microwave
oven
3. Reattach the 2 screws.
4. Tape the microwave oven door closed so that door does not
swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip or
use the door or door handle while the microwave oven is being
handled.
IZO al : '
The microwave oven is set for recirculation installation. For wall or
roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using recirculation installation.
Keep the damper assembly in case the venting method is
changed, or the microwave oven is reinstalled in another location
where wall or roof venting may be used.
Wall Venting Installation
Only
1. Remove damper plate screw and top blower motor screw
attaching damper plate to top of microwave oven exterior. Lift
up damper plate.
..................
C
INSTRUCTIONS
2. Remove the blower motor screw from the back of the
microwave oven, then lift out blower motor.
3.
6
A. Blower motor
B. Blower motor screw
Using diagonal wire cutting pliers, snip out the rear damper
vent covers at the perforations.
-
S
4,
\ c)_
I
//
'
A. Damper vent covers
B. Perforations
C. Diagonal wire cutting pliers
Rotate blower motor 180 ° so that exhaust ports face the back
of microwave oven, and lower blower motor back into the
microwave oven.
5.
A
A. Exhaust port
Close damper plate, and reinsert top blower motor screw
removed in Step 1.
'_' . .................................
A
B
A. Damper plate screw
B. Damper plate
C. Top blower motor screw
B
i
G_%
A. Top blower motor screw
B. Damper plate
4

Advertisement

Table of Contents
loading

  Also See for Maytag MMV4203DB - 2.0 cu. Ft. Combination Range Hood-Microwave

  Related Manuals for Maytag MMV4203DB - 2.0 cu. Ft. Combination Range Hood-Microwave