Advertisement
•
Assemble the two hitch brackets to the front of
the
hitch tubes using two 5/16" x 2-1/4" hex bolts, 5/16"
lock washers and 5/16" hex lock nuts. Do not
tighten yet. See figure 3.
•
Assemble the hitch pin to the hitch brackets and
secure it with the 1/8" hair cotter pin. See figure 3.
5/16" x 2-1/4"
F
HEX BOLT
_._
HITCH PIN
HITCH
1/8" HAIR
,_>"_
CO'r'rER PIN
FIGURE 3
•
Assemble the boom mount bracket to the rear of the
hitch tubes using two 5/16" x 1-3/4" carriage bolts,
5/16" lock washers and 5/16" hex nuts. Do not
tighten
yet. See figure 4.
5/16" x 1-3/4"
CARRIAGE BOLT
\
BOOM MOUNT
BRACKET
5/
WASHER
_16" HEX NUT
FIGURE 4
Slide the axle through the two axle brackets. As-
semble a spacer, a 1/2" flat washer, a wheel and
another 1/2" flat washer onto the axle. Lightly tap a
hub cap onto the end of the axle. Repeat on other
end of axle. See figure 5.
I_"
FLAT WASHER
SPACER
\
HUB CAP
FIGURE 5
Tighten the four bolts which fasten the hitch tubes to
the bottom of the tank. See figure 2.
Tighten the four hex nuts which fasten the axle
brackets to the hitch tubes. See figure 1.
Tighten the two bolts which fasten the front of the
hitch tubes together. See figure 2.
Tighten the two bolts which fasten the hitch brackets
to the hitch tubes. See figure 3.
Tighten the two bolts which fasten the boom mount
bracket to the rear of the hitch tubes. See figure 4.
Install the drain in the rear of the tank as shown in
figure 6. Place a 3/4" garden hose gasket onto the
drain body and insert the drain body out through the
hole in rear of the tank. Outside the tank, assemble
the nylon washer and then the nylon nut onto the
drain body. Tighten the nut securely enough to
prevent leaking, being careful not to damage the
plastic parts. Place the O-ring inside the nylon cap
and screw the cap onto the end of the drain body.
NYLON
WASHER
NYLON NUT
O-RING
NYLON CAP
DRAIN BODY
HOSE
GASKET
FIGURE 6
•
Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock
washers (between the bar and bracket), 5/16" fiat
washers and knobs. The boom connecting
hose
should extend upward. See figure 7.
NOTE:
Make sure the nozzles are adjusted so that the
openings face straight down when the boom bar is in
the horizontal operating position.
5/16" WASHER
KNOB
BOOM BAR
CARRIAGE BOLT
5/16" x 1-1/4"
FIGURE 7
5
Advertisement
