Symptoms; How To Fix; Tmsliveservice - TANDBERG TELEPRESENCE MANAGEMENT SUITE - ADMININSTRATION GUIDE 13.0 Administration Manual

two seconds up to approximately 20 seconds (worst case). This means that scanning 100 systems
might take from three minutes up to 30 minutes.
The scanner will read the system connection status and call status on every scan, but will only read
the full system configuration in intervals defined in the field System Force Refresh Interval (in
hours). The scanner will update 20 connection statuses in parallel and read five full system
configurations in parallel.
To improve response time, Cisco TMS runs an extra connection status check each 30 seconds for
systems in these categories:
Cisco TelePresence MCU
gateways
gatekeepers
bordercontrollers
recording devices
supervisors
System types included (in addition to the categories mentioned above):
Cisco TelePresence Server (TS 7010)
Cisco TelePresence System (CTS)

Symptoms

The symptoms are that the system information and system status in Cisco TMS is outdated. Systems
not responding still have the status InCall or Idle.

How to fix

1. Check the logs for symptoms or error messages at c:\Program
Files\TANDBERG\TMS\wwwTMS\Data\Logs\tmsdebug\log-TMSDatabaseScanner.txt on the
server.
2. Restarting the service or the Cisco TMS server will normally fix any problem with this service.

TMSLiveService

This service:
allocates conferences on the Cisco TelePresence MCU
issues the dial commands to the endpoints and the Cisco TelePresence MCU
monitors the activity of the participants during a conference
Symptoms
The call does not start, and the log in the Conference Control Center is almost empty.
You could have only one line that says "Created" in the log. You might have more lines there if the
conference has been changed – but none of them is related to launching the conference.
How to fix
1. Check the logs for symptoms or error messages at c:\Program
Files\TANDBERG\TMS\wwwTMS\Data\Logs\tmsdebug\log-liveservice.txt on the server.
2. Restarting the service or the Cisco TMS server will normally fix any problem with this service.
Cisco TMS Administration Guide
Troubleshooting the Cisco TMS components
Page 28 of 37