Related Manuals for TANDBERG 420LTO
Summary of Contents for TANDBERG 420LTO
- Page 1 Tandberg 420LTO Half Height LTO2 Tape Drive Quick Installation Guide Revision 1 – February 2005...
-
Page 2: Mechanical Installation
• Minimum required screw penetration: 2.0 mm requirements • Screw torque, mounting screws: 0.5 Nm • Screws are supplied with all the Tandberg 420LTO drive variants Do not use longer screws or higher screw torque than specified! Figure 2 Allowed mounting orientations... - Page 3 SCSI Identification Make sure that the drive unit has the proper SCSI-ID before it is connected to a computer system. Refer to manuals for host computer and application software to obtain the correct ID. For correct mounting of ID-jumpers at the rear of the drive, please refer to Figure 3 and Table 1.
-
Page 4: Scsi Cable
If the tape drive is the last device on the bus, the bus must be terminated within 10 cm of the tape drive connection. Tandberg 420LTO has a combined SCSI-LVD/SE interface embedded. The PC-98 Specification specifies that the termination of the SCSI-bus system is a part of the SCSI-cable and not a part of the SCSI-device. -
Page 5: Front Led Indicators
ON / OFF Flashing Over temperature ON / OFF Media Error (wrong, write protected or Flashing ON / OFF Flashing harmed media) Table 2 Front LED behavior during normal operation For a complete description of LED behavior see Tandberg 420LTO Reference Manual. -
Page 6: Power Requirements
Figure 6 External tabletop enclosure, rear side Power Requirements Tandberg 420LTO in external tabletop enclosure: AC Input: 100 VAC / 0.6 A or 240 VAC / 0.3 A, 50-60 Hz Tandberg 420LTO as standalone: DC Input (typical operation): 5 VDC / 2.1 A, 12 VDC / 0.6 A... - Page 7 We guarantee that this product left our premises defect free. If you are not satisfied with the quality of this product, please contact your distributor or the nearest Tandberg Data office to have the problem solved! For more documentation and information, please see our website www.tandberg.com.
- Page 8 Tandberg Data International headquarters Tandberg Data ASA, Kjelsåsveien 161, Oslo, P.O. Box 134 Kjelsås, N-0411 Oslo, Norway. Tel: +47 22 18 90 90. Fax: +47 22 18 95 50. www.tandberg.com Worldwide subsidiaries Inostor Inc., 13000 Gregg Street, Poway, CA 92064, U.S.A.