Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TANDBERG LTO HH
Summary of Contents for TANDBERG LTO HH
- Page 1 Tandberg Tandberg LTO HH Tandberg Tandberg LTO HH LTO HH LTO HH LTO- - - - 1, LTO 1, LTO- - - - 2, LTO 2, LTO- - - - 3 3 3 3 1, LTO 1, LTO 2, LTO...
-
Page 2: Mechanical Installation Internal Tape Drive
2.0 mm • requirements Screw torque, mounting screws: 0.5 Nm • Screws are supplied with all the Tandberg 220/420/820LTO drive • variants Bags with 4 screws and 4 SCSI ID jumpers are available • (Ordering no. 43 32 65) Do not use longer screws or higher screw torque than specified! - Page 3 SCSI Identification on Internal Tape Drive Make sure that the drive unit has the proper SCSI-ID before it is connected to a computer system. Refer to manuals for host computer and application software to obtain the correct ID. For correct mounting of ID-jumpers at the rear of the internal drive, please refer to Figure 3 and Table 1 for internal tape drive.
- Page 4 SCSI specifications. If the tape drive is the last device on the bus, the bus must be terminated within 10 cm of the tape drive connection. Tandberg LTO-1, LTO-2, LTO-3 have a combined SCSI-LVD/SE interface embedded. The PC-98 Specification specifies that the termination of the SCSI-bus system is a part of the SCSI-cable and not a part of the SCSI-device.
- Page 5 Termination External Tape Drive External devices must be terminated with an external terminator on the last device on the SCSI-bus. Please see Figure 5 for SCSI connectors and Figure 6 for SCSI termination. External terminator on the last device on the SCSI bus SCSI Interface adapter Figure 6 External SCSI cabling and termination...
-
Page 6: Front Led Indicators
Front LED Indicators Figure 7 Light Emitting Diodes (LED) READY LED ACTIVITY LED CLEAN LED FAULT LED Drive State (Green left) (Green) (Amber) (Amber right) LED-test. The LEDs are turned ON one-by-one. Power-On Self-Test starts in parallel with the LED-test . Cartridge not loaded. -
Page 7: Software Installation
For installation of Backup Application software, refer to the software vendor’s software application user guide supplied with the software or on the software vendor’s web. Media and Capacities To achieve and maintain the maximum quality of your Tandberg Data tape drive, we recommend using Tandberg Data media. Drive Media Name... -
Page 8: International Headquarter
Tel: +33 1 39 26 01 01/00800-82632374. Fax: +33 1 34 65 02 89 (for technical support: 00800-07867243). Tandberg Data (Asia) Pte. Ltd, 20 Bendemeer Road, #04-05 Cyberhub, Singapore 339914, Tel: +65 6396 0786. Fax: +65 6396 0787. Tandberg Data (Japan) Inc., Eitaibashi Eco-Piazza Bldg. 8th floor 29-13, Shinkawa 1-chome, Chuo-ku Tokyo 104-033, Japan Tel: +81 3 5566 2871.