Dremel 335 Operating/Safety Instructions Manual page 5

DM 2610920458 2-04 2/19/04
Adjusting Routing Depth
NOTE: When making deep cuts, especially
plunge cuts away from the edge of the work-
piece, it is recommended to make several
successive cuts progressively deeper using
the depth adjustment and depth scale rather
than making one single deep cut.
The depth limiter can be adjusted for two
depths.
1. Place your Dremel Rotary Tool and Router
assembly on the workpiece.
2. Turn the upper adjustment nut upward
3. Loosen the locking hand grip (Fig. 6).
Slowly lower the tool until the router bit
just touches the workpiece.
4. Tighten the locking hand grip to lock the
tool in place.
5. Press and hold the release button so
depth stop touches the router base.
1st Routing Depth
6. Turn the depth stop upwards so that
measurement X equals the first desired
routing depth (Fig. 7).
NOTE: 1 turn equals .06" (1.5 mm)
7. Turn the upper adjustment nut down
snug against the router frame.
2nd Routing Depth
8. Turn the depth stop upwards so that
measurement X equals the second
desired routing depth. Make sure upper
adjustment nut turns with the depth stop,
so it rises away from router frame (Fig. 8).
9. Turn the lower adjustment nut up snug
against the router frame.
NOTE: The upper adjustment nut must
remain stationary when tightening the lower
adjustment nut.
12:24 PM Page 5
and turn the lower adjustment nut down-
ward so depth stop is free to move (Fig. 5).
FIG. 5
FIG. 6
1
Hand
Grip
Depth
FIG. 7
Stop
Upper
Adjustment
Nut
FIG. 8
Depth
Stop
5
Depth
Upper
Stop
Adjustment
Nut
Lower
Adjustment
Nut
Release
Button
X
X
X
Lower
Adjustment
Nut
X