Advertisement
How to Add Fluid
Refer to the Maintenance Schedule to determine what
kind of transaxle fluid to use. See "Recommended
Fluids and Lubricants" in the Index.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the cross-hatched area on the
dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it to the proper level. It doesn't
take much fluid, generally less than a pint (OSL).
Dun
't
overfill. We recommend you use only fluid
labeled DEXRON@-111, because fluid with that label
is
made especially for your automatic transaxle.
Damage caused by fluid other than DEXRON@-I11
is not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as
described under "HOW to Check.''
When the correct fluid level is obtained, push the
dipstick back in all the way.
Engine Coolant
The following explains your cooling system and how to
add coolant when it is low. If you have a problem with
engine overheating, see "Engine Overheating" in the
Index.
The proper coolant for your Buick will:
Give freezing protection down to -34°F (-37°C).
0
Give boiling protection up to 262°F (128
"
C).
Protect against rust and corrosion.
Help keep the proper engine temperature.
Let the warning lights work as they should.
What to Use
Use a mixture of one-half clean water (preferably
distilled) and one-half antifreeze that meets "GM
Specification 1825-M," which won't damage aluminum
parts. You can also use a recycled coolant conforming to
GM Specification 1825-M with a complete coolant flush
and refill. Use GM Engine Coolant Supplement (sealer)
with any complete coolant flush and refill. If you use
this mixture, you don't need to add anything else.
6-21
Advertisement
