To Install The Remote Lever; Using The Mag Resistance Unit; About The Maximum Resistance Level - MINOURA E-RDA-1050R-POWERMATIC Instruction Manual

HOW TO INSTALL THE REMOTE LEVER
You can install the remote lever on anywhere the diameter is between 22.2mm (7/8") and 31.8mm (1-1/4") like
as on the handlebar.
Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder.
1
(see Fig. J)
Place the holder onto the handlebar, shut the holder, and pull up the bolt then tighten it. (see Fig. K)
2
(Fig. J)
Depending on the diameter of your handlebar, you must adjust
the shim as follows;
• 22.2mm (7/8") - 25.4mm (1"):
• 28.6mm (1-1/8"): Install either right or left side shim.
• 31.8mm (1-1/4"): Remove both shims.

USING THE MAG RESISTANCE UNIT

The Mag unit has 7 different levels of load force for replicating actual riding resistance. You can set your pre-
ferred maximum resistance point between high (H) and low (L) by adjusting the lever on the thumb shifter type
remote lever device (see Fig. M). The resistance level will automatically be controlled from zero to maximum
depending on your riding speed.
You may also adjust the load force by shifting up or down among your gears,
depending on the level desired.
We recommend that you start with a medium to low load force and gradually
work up, increasing force as your muscles warm up.

About the Maximum Resistance Level

About the Maximum Resistance Level About the Maximum Resistance Level
About the Maximum Resistance Level About the Maximum Resistance Level
Please Note: Please Note: The remote lever of the PowerMatic sets the highest resistance level of the Mag unit, not the Please Note:
Please Note: Please Note:
overall resistance like other trainers.
The resistance will always start from zero even you set the remote lever at any position. It will be increased when
you start pedalling gradually and progressively. You can see it as the motion of the side indicator on the Mag unit
(see Fig. N).
(Fig. K)
Install both shims.
- 6 -
Shim
(Fig. L)
!
When you install the shim
on the plastic holder, make
sure the direction of the
shim as shown in Fig. L.
(Fig. M)