To Setup - MINOURA E-RDA-1050R-POWERMATIC Instruction Manual

HOW TO SETUP YOUR E-RDA-PM TRAINER
Open the frame support legs and fit the rubber feet at the correct angle so the base is in full contact with
1
the floor.
NOTE: If the both legs don't touch the floor at same time and if one side of the leg is still slightly raised, pull up the
leg upward strongly then place the trainer on the floor again.
Install the Mag resistance unit on the left side slot and
2
the assistant roller on the right side slot beside the trainer
pilar using the supplied M6x12 bolts. (see Fig. B)
NOTE: We recommend you use the reinforcement plate (SR-
13) for installing the Mag unit. This plate will sandwich the
slot plate from outside for mounting the Mag unit giving it
extra stability.
Open both couplings by turning the left side knob (see Fig. C) and the right side hub handle
3
(see Fig. D) anti-clockwise.
Do not over-loosen the couplings, otherwise the knob or the hub handle may become unthreaded
inside the frame.
Left Side Knob
NOTE: We suggest not using the left side coupling for major adjustment. NOTE: NOTE:
NOTE: NOTE:
Moving it too much to one side will cause misalignment. The left side cou-
pling is used only to provide easy intitial adjustment for your hub length.
(see Fig. E)
Insert the left side of the skewer (Q/R lever side) into the left side cou-
4
pling, and adjust the rotation of the coupling so the skewer lever sits
securely in the large cut-out (see Fig. F). This will prevent damage to the
skewer during use.
<Required Tools: M5 hex wrench>
(Fig. C)
- 4 -
Right Side Hub Handle
(Fig. D)
(Fig. B)
(Fig. E)
(Fig. F)