Using The Plastic Skewer Nut Protector - MINOURA E-RDA-1050R-POWERMATIC Instruction Manual

Indoor bicycle trainer

Table of Contents

Hold the bike firmly by hand and turn the right side hub handle clockwise until the coupling comes into

contact with the right side skewer nut.

Adjust each height of the Mag unit and the assistant

roller to fit to your rear wheel perfectly and tighten the

bolts firmly. (see Fig. G)

Each rubber roller is made to contact the rim ONLY.

Contact with the tire may cause the tire to burst

during use.

Adjust the wheel position by checking the double-circle

position indicators on both sides.

The best position should be each indicator can be seen

equally, but if your rim is narrow, you should adjust

the wheel position to be a little left (toward Mag side)

to prevent unexpected slippage problem.

NOTE: Note that the left side knob is NOT for tightening

NOTE:

the axle. It is only for positioning the wheel. Clamping

wheel securely must be done by the right side hub handle.

USING THE PLATIC SKEWER NUT PROTECTOR

We recommend that you use the supplied skewer if at all possible. This

will guarantee a fit with our couplings and remove any chance of mis-

alignment.

The right side coupling has a black plastic skewer nut protector (called a "Grommet"). This is to protect your

skewer from damage during use, however, should you choose to use your own skewer, you should use the

supplied Grommet to insure a better fit.

5If your skewer nut design doesn't fit to the Grommet, you can remove it by inserting a rod or a pen to the hole

(see Fig. I) and then lifting up the Grommet.

NOTE: We will NOT guarantee any fitting problem or accident caused by using your own skewer on the

trainer.

When you use the supplied skewer, you should keep the Grommet on the coupling.

- 5 -

(Fig. G)

(Fig. H)

Hole

(Fig. I)

Table of Contents

Show Quick Links

Table of Contents