HYOSUNG TE 450 Manual page 64

7. Reinstall the oil tank drain plug ③ , and
the crankcase drain plug ④
do not overtighten them.
�
8. Loosen the oil filter ⑤
and remove it with a filter wrench of
proper size.
9. Wipe off the mounting surface on the
engine where the new oil filter will be
seated with a clean rag.
10. Smear a little engine oil around the
rubber gasket of the new oil filter.
CAUTION
When replacing the oil filter, it is
highly recommended that you use a
genuine HYOSUNG oil filter designed
for your ATV, as other filters may have
different design
specifications which could cause
engine damage or oil leaks.
securely, but
�
counter-clockwise
and thread
11. Screw on the new oil filter by hand until
the filter gasket contacts the mounting
surface (a small resistance will be felt).
To tighten the oil filter properly, it is
important to accurately identify the
position at which the oil filter gasket
first contacts the mounting surface.
12. Pour fresh oil through the filler hole of
the oil tank and the filler hole of outer
cover ⑥ . Approximately 2,600 ㎖
will be required.
N O T E
Approximately 2,500 ㎖ ㎖
required when changing oil only
without replacing the oil filter.
13. Install the oil level gauge of the oil tank
and the outer cover of crankcase.
Failure to use the correct oil can
damage your ATV.
Engine damage may occur if you use
oil that does not meet Hyosung's
specifications.
Be sure to use the oil specified in the
FUEL, ENGINE OIL AND COOLANT
RECOMMENDATION section.
64
CAUTION
of oil will be
CAUTION
of oil