Panasonic 30 - Toughbook - Core 2 Duo Service Manual page 39

■ Line Processing of Antenna Cable and LCD Cable
Step1
Install the Holder and Cable guide on the Hinge as shown in figure.
Cable Guide HInge
Keep margin in cable length
Step3
Fit Holders as shown in figure
S2
(Until you hear the click)
Watch out is the cable comes off from the holder
for cable is not scissored between the holder and hinge.
Step5
Next, wrap (one round) the LCD Cable around
the axis of the Hinge as shown in figure.
Safety Working
S1:Insulation S2:Pinching Cables S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Others
Cable Holder
It prevents to break of the cable
S5
Step4
Red marking is
on the holder
Black marking is
on the holder
Step6
39
Step2
<CAUTION>:Position of the Antenna Cables
LCD cable proccess space
ANT cable proccess space
Wrap (one round) only the Antenna Cables around
the axis of the Hinge as shown in figure.
Note: Handle LCD cable as show in figure. LCD cable
must not intersect with Antenna Cables.
CAUTION:Check the position of the Cables
OK
NG
The antenna cables must not intersect with the LCD cable.
/ 90
Cable Holder
Insert the cables into the Cable Holder as shown in figure.
Right side of LCD Cable:White/Gray
Left side of LCD Cable:Blue/Black/Brown
It prevents to
break of the
cable
S5