Panasonic 30 - Toughbook - Core 2 Duo Service Manual page 37

■ Line Processing of Antenna Cable
Note: Avoid any stress on the solder.
Screw
EVDO/EDGE Antenna
S2
Details of "A"
Avoid running over
the rib, etc..
Screw
Put the Cable on each hook
Screw
LAN-AUX ANT
Screw
Match to the edge of Cabinet
S2
Details of "D"
Put the Cable on each hook
Avoid running over
the rib, etc..
9.2.4. Setting up the LCD Hinge
1. Wind the Cable coming out of the LCD Unit counterclock-
wise to the LCD Hinge.
2. Set the Lock Plate and the Hinge Top Cover, and rotate
the LCD Hinge to turn the Display Unit to front
3. Put the LCD Cable and the Antenna Cable in the Cable
Holder.
4. Fit another Cable Holder and clamp the Cable Holders in
the LCD Hinge.
5. Fix the LCD Hinge using the 2 Screws <N17> and the 2
Cable Holder Plates.
Screws <N17 > : DXYN3+J8FNL
Safety Working
S1:Insulation S2:Pinching Cables S3:Sharp Edge
CAUTION
S4:Part No. Check S5:Others
Match to the edge of Cabinet
A
Cable Cushion Attachment Method
(3 Places)
Bundle and wind 3
antenna cables.
C
Cable Cushion
Cable Cushion
Put the center of Cushion between the ribs.
37
Insert it between the wall and the rib after attaching.
Cable Cushion
Avoid running over the rib, etc..
Details of "D"
Insert it between the pins.
Hook it.
Tape Pen Holder
Cable Holder
Plate
/ 90
S2
Details of "B"
Avoid running over
the rib, etc..
Match to the edge of Cabinet
B
S2
D
Put the Cable on each hook
Cable Cushion
Cable
<N17>
Holder
Cable
<N17>
Plate
Holder
Plate
LCD
Hinge
Cable
Holder
LCD Cable
Holder
Sheet
Cable
Holder
Screw
LAN Main
/BT ANT
Screw
Match to the
edge of Cabinet
Screw
EVDO-AUX
Screw
Match to the
edge of Cabinet