Calibrating The Status Gauge; Formatting The Memory Card - Epson r-d1 - Rangefinder Digital Camera User Manual

Calibrating the Status Gauge

The gauge readings may deviate slightly from the set positions over
time. If this happens, follow the steps below to calibrate the gauge
needles.
1. Press (LCD) then (MENU) to display the main menu on the
LCD monitor.
2. Select (Settings), (Basic Setup), then Calibrate Needles
using the jog dial, then press
3. Select the needle you want to calibrate using the jog dial, then press
(ENTER).
Needle Calibration
Please calibrate
carefully.
S e lect
4. Select or r using the jog dial, then press
l
to adjust the needle position on the status gauge.
42
Maintenance and Troubleshooting
(ENTER).
Finish
B a c k
(ENTER) repeatedly
5. Select Finish using the jog dial, then press
6. Repeat steps 2 through 4 if you want to calibrate the other needles.
7. Select Finish using the jog dial, then press

Formatting the Memory Card

Format the memory card when you want to erase all the data on the
card, or if the memory card has been formatted with a computer or
another digital camera and you cannot save any images on the card.
Follow these steps:
1. Press (LCD) then (MENU) to display the main menu on the
LCD monitor.
2. Select (Settings) then
then press (ENTER).
3. Select Quick Format or Full Format using the jog dial, then press
(ENTER). The confirmation screen is displayed.
4. Select OK using the jog dial, then press
The formatting starts and the message "Formatting..." is displayed.
After the memory card is formatted, the screen returns to the
Settings menu.
Note:
❏ When you format the memory card, all the data on the card will be lost,
including the locked images.
❏ If the memory card is locked, the message "Cannot format. The SD card
is write-protected" is displayed. Remove the card from the camera, then
unlock the card and try again.
(ENTER).
(ENTER).
(Format SD Card) using the jog dial,
(ENTER).