Completing the installation
This section describes how to complete the installation.
Installing the cover and bezel
Complete the following steps to install the server cover and bezel:
1. Position the internal cables so they do not interfere with the cover installation.
2. Position the cover on top of the server and slide it forward. Press down on the
3. If you removed the bezel, position the bezel directly in front of the server and
4. If you removed the USB option tray, insert it fully into the slot below hard disk
5. Install the server in the rack. See the Rack Installation Instructions that come
6. To attach peripheral devices, connect the server to other servers, and connect
Cabling the server
To share one monitor, keyboard, and pointing device (such as a mouse) among
multiple servers, connect the servers using Cable Chain Technology (C2T). In
addition, you can create an Advanced System Management (ASM) interconnect
network of connected servers by installing one or more Remote Supervisor
Adapters.
See the section about using the Configuration/Setup Utility program in the
User's Guide for details.
Attention:
Before sliding the cover forward, make sure that all the tabs on
both the front and rear of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
cover latch. The cover slides forward into position. Ensure that the cover
engages the tabs at the front and rear of the server.
press it into place so that the retention tabs snap into the holes on the top, right
side, and bottom of the server.
drive bay 1.
with the server for details.
Notes:
a. Depending on the options that you installed, after cabling the server you
might need to run the Configuration/Setup Utility program to update the
server configuration. See "Using the ServerGuide Setup and Installation CD"
on page 9.
b. If you installed a SCSI drive, check the LEDs to verify proper operation.
the power cord, continue with "Cabling the server."
Chapter 4. Customer replaceable units
59