IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual page 98

Note: See "System" on page 112 to determine which components should be replaced by a field service technician.
Error code/symptom
206-XXX-000
(Failed diskette drive test)
215-XXX-000
(Failed IDE CD-ROM drive test)
217-198-XXX
(Could not establish drive parameters)
217-XXX-000
(Failed hard disk drive test)
Note: If RAID is configured, the hard disk
drive number refers to the RAID logical
array.
217-XXX-001
(Failed hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
264-XXX-0NN
(Failed tape drive test)
264-XXX-999
(Errors on multiple tape drives, see error
text for more info)
301-XXX-000
(Failed keyboard test)
405-XXX-000
(Failed Ethernet test on controller on the
system board)
405-XXX-00n
(Failed Ethernet test on adapter in PCI slot
n)
405-XXX-a0n
(Failed Ethernet test on adapter in PCI slot
a)
415-XXX-000
(Failed Modem test)
88
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Rerun the test using another diskette.
2. Cable.
3. Diskette drive.
4. System board.
1. Rerun the test using another CD-ROM.
2. CD-ROM drive cables.
3. CD-ROM drive.
4. System board.
1. Check cable and termination.
2. SCSI backplane.
3. Hard disk drive.
v Hard disk drive 1
v Hard disk drive 2
1. Tape cartridge, if user executed the Read/Write Tape Drive test
(failure code of xxx = 256)
2. SCSI or power cable connected to tape drive with SCSI ID nn
3. Tape drive with SCSI ID nn (refer to the Help and Service
Information appendix of the tape drive's User Guide)
4. System board or SCSI controller (run SCSI controller diagnostic to
determine if the SCSI bus is functioning properly.)
v See error messages/text in the PC Doctor error log for detailed
information on each individual tape drive error.
v Keyboard
v System board.
1. Verify that Ethernet is not disabled in BIOS.
2. System board.
1. Adapter in PCI slot n
2. System board
1. For a = 0, system board
2. For a > 0, adapter in PCI slot a
1. Cable
Note: Ensure modem is present and attached to server.
2. Modem
3. System board