Replacing The Heat Sink And Fan Assembly - Lenovo 0809B3U User Manual

Replacing the heat sink and fan assembly

This section provides instructions on how to replace the heat sink and fan
assembly.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before removing the
computer cover.
To replace the heat sink and fan assembly, do the following:
Figure 18. Removing the heat sink fan duct
24
User Guide
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
1. Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 14.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on
page 15.
4. Pivot the drive bay assembly upward. Remove the four screws that secure the
heat sink fan duct and then lift the heat sink fan duct up to remove it from
the chassis.
5. Disconnect the heat sink and fan assembly cable from the microprocessor fan
connector on the system board. See "Locating parts on the system board" on
page 11.