6. Connect one end of the signal cable to the rear of the new hard disk drive and
Figure 35. Connecting a SATA hard disk drive
7. Position the new hard disk drive into the hard disk drive bay and align the
Figure 36. Installing the hard disk drive
40
User Guide
the other end to an available SATA connector on the system board. See
"Locating parts on the system board" on page 11. Then, locate an available
five-wire power connector and connect it to the rear of the new hard disk
drive.
screw holes in the new hard disk drive with the corresponding holes in the
drive bay. Then, install the four screws to secure the new hard disk drive in
place.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to "Completing the parts
replacement" on page 44.