Keyboard And Mouse Problems - Gigabyte GB-AEDNK User Manual

Keyboard and mouse problems

Symptom
Keyboard or mouse
commands are not
recognized by the com-
puter.
I cannot type numbers
using the numeric key-
pad.
The cursor moves slowly
and does not respond
to the movement of the
mouse.
The cursor moves too
fast or too slow.
GB-AEDTK
• If you are using a wired keyboard or mouse, check the cable connection
between the unit and your computer.
• If you are using a wireless keyboard or mouse, check the following items.
• Ensure the USB receiver is properly connected to the computer, and the
keyboard or mouse is within range.
• If your keyboard or mouse has a power button, turn it on.
• Press the Connect button on the keyboard or mouse to rebuild the con-
nection between the unit and your computer.
• Try replacing the batteries in the wireless keyboard or mouse.
• Restarting the system to detect the wireless connection again
• Check if the Num Lock indicator on your keyboard is on.
• If the Num Lock indicator is off, that means the numeric keypad is not
activated. Press the <Num Lock> key to activate the numeric keypad.
• If you are using a traditional mouse, check the following items:
• Use a mouse pad or other rough surface under the mouse.
• Clean the mouse. Remove the mouse compartment cover and ball from
the mouse and carefully wipe the mouse ball with a moistened cloth or
scrap the rollers to remove any dirt. Then leave the mouse ball for a while
to dry out before reassembling the mouse.
• If you are using an optical mouse (either wired or wireless), refer the following
items.
• Use a mouse pad or white sheet of paper under the mouse.
• Clean the mouse by gently wiping the light sensor lens on the bottom of
the mouse with a lint-free cloth.
• You may configure the cursor speed to meet your personal preferences.
• Click Start > Control Panel > Mouse to open the Mouse Properties dialog
box.
Click Pointer Options tab and drag the Motion slider toward Slow or
Fast to adjust the speed at which the cursor responds to mouse
movement.
When done, click OK to finish the configuration.
Possible Solution
30