Dodge 2009 KA Nitro Owner's Manual page 109

From outside the UConnect
mode):
Press and hold the VOICE RECOGNITION button for
five seconds until the session begins, or,
Press the VOICE RECOGNITION button and say the
Setup, Voice Training command.
Repeat the words and phrases when prompted by the
UConnect system. For best results, the Voice Training
session should be completed when the vehicle is parked
with the engine running, all windows closed, and the
blower fan switched off.
This procedure may be repeated with a new user. The
system will adapt to the last trained voice only.
To restore the Voice Recognition system to factory default
settings, enter the Voice Training session via the above
procedure and follow the prompts.
mode (e.g., from radio
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 107
Voice Recognition (VR)
For best performance, adjust the rearview mirror to
provide at least ⁄ in (1 cm) gap between the overhead
1
2
console (if equipped) and the mirror.
Always wait for the beep before speaking.
Speak normally, without pausing, just as you would
speak to a person sitting a few feet/meters away from
you.
Make sure that no one other than you is speaking
during a voice recognition period.
Performance is maximized under:
low-to-medium blower setting,
low-to-medium vehicle speed,
low road noise,
smooth road surface,
3