Table of Contents
Advertisement
2.9.2
Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1.
Install the SATA hard disks into the drive bays.
2.
Connect the SATA signal cables.
3.
Connect a SATA power cable to the power connector on each drive.
2.9.3
Intel
This motherboard supports RAID 0, RAID 1, RAID 5, RAID 10 and Intel
Storage configurations for Serial ATA hard disks drives through the Intel
Southbridge chip.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1.
Enter the BIOS Setup during POST.
Go to Main > Storage Configuration > Configure SATA as, then press
2.
<Enter>.
Select [RAID], then press <Enter>.
3.
5.
Save your changes, then exit the BIOS Setup.
ASUS A500/AS-D920, BA5190
A500 AS-D920.indb 35
RAID configurations
®
Matrix
®
ICH10R
®
2-35
4/12/10 5:53:43 PM
Advertisement
Table of Contents
